Farmall & IHC Tractors Discussion Board |
Rear Rim to Hub Clamps - Proper way to attach?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad Whitty on October 26, 2001 at 23:12:44 from (66.42.117.70):
I have a 1941 MD and I have new tires mounted on their 38" rims. The way my rims attach to the hubs are as follows: The bolt begins from the back side of the hub, passes through the first rim clamp, then through the hub, and then a jam nut is attached on the otherside, then the second clamp is slid over the bolt, and finally the nut goes on the end. "Is this correct?" My manuals do not show illustrations of the mounting clamps and their related parts. I was thinking the Jam nut is not necessary as it makes the outer clamp sit far from the rim, unless you reverse it. Any input is much appreciated as this is my first tractor I have owned. Thanks! Brad
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Silver King - by Staff. Silver King tractors were produced by the Fate-Root-Heath Company of Plymouth, Ohio. The company was founded by John Fate in 1884 and was originally called the "J.D. Fate Company". After several mergers over the years, the final company name of Fate-Root-Heath came about in 1919. The first tractor produced was actually called the "Plymouth" tractor and was powered by a 20 HP 4-cylinder engine with a 3x4" bore and stroke. The four speed transmission had a top speed of 25 mph! After more t
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|