Farmall & IHC Tractors Discussion Board |
BN engine and H carb questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on September 20, 2001 at 07:41:08 from (63.150.94.35):
1. I'm getting a BN in a couple of years. The tractor has been sitting outside in northern Michigan for ten years without a muffler (the exhaust pipe is exposed to the elements). In order to help preserve what's left of the engine, I was going to fill up the manifold/combustion chamber and the crankshaft/cam/bottom half of the engine with fuel oil; my hope was it would penetrate the engine and stop further rusting. Is this a good idea, or is there a better way? How many gallons would I need for this? 2. The carbs on my two H's and SMTA drip gas out of the bottom of the carb when I turn it over (and it doesn't start immediately). There's a steady trickle for about 1 to 2 seconds. When the tractor starts and runs, this doesn't happen. Is this normal? If not, what can I do about it? I rebuilt them, the floats don't appear stuck, and I have the main fuel jet turned in to the point where the tractor is on the border of konking out. Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|