Farmall & IHC Tractors Discussion Board |
Filling hydraulic resevoir on Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by marvin on August 24, 2001 at 10:09:54 from (134.134.248.28):
The resevoir on my Super A for the Hydraulic fluuid was low. So I filled it to the top of the fill plug. The manual says to fill within 1/2' of the top and then to start the engine and cycle the Touch Control 10 or 12 times to get any air out of the system. When I leave the plug out it just pumps the oil onto the ground. Perhaps it does this because I filled it too full. It is also milky yellow in color. Should I just drain the fluid to get it down to the 1/2" below the fill plug and then cycle the Touch control? How often should one clean the filter for the Hydraulic? How often should the fluid be changed? Also the hydraulic unit that contains the valves and the pistons has slow leaks. What typically fails here and how difficult is it to repair? I would like to get rid of all of the leaks on my Super A.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|