Farmall & IHC Tractors Discussion Board |
Re: Re: Re: M governor rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on July 30, 2001 at 04:34:53 from (12.84.239.66):
In Reply to: Re: Re: M governor rebuild posted by jiM on July 30, 2001 at 03:39:04:
I am having trouble decifering your decifering! If your RPM is not holding steady or the engine starts losing RPM when you place a load on it, it might be a combination of a weak spring and a wobbly thruster bearing behind the spring. That thruster bearing should slide horizontally on the shaft but not wobble. Also make sure you got the governor shaft connected correctly into the slot in the butterfly on the carburetor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Repairing A Massey Harris 22 - by John Reeves. I have just given this old girl (boy?) a replacement RH rear axle. I was lucky enough to find an axle in good shape at a reasonable price - also a replacement for the right rear brake assembly which was
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|