Farmall & IHC Tractors Discussion Board |
Help With H Steering!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 1PWRFULH on July 16, 2001 at 15:12:08 from (63.23.233.175):
Ok well I decided today to take a look at the H's steering because at full speed that thing wobbles so badyou just wonder if something is going to break. Took the shaft apart at the u joint and it appears that the worm gear has too much play in it. It allows the rod to turn quite a bit before moving the sector gear. That big plug was as tight as it wuld go and the bearing in there looks fine. I dont think that it is nothing more than those 2 gears. Can I get replacements or what is the easiest way? Is that worm gear made onto that shaft meaning I would have to buy the whole shaft too or not? Everything was covered in soo much grease I couldnt see it very well. I tried turning the gear 180 degrees like I read in the archives but it didnt help. Suppose you are looking at one of the steering wheel spokes when it is straight up the spoke will move about 60 degrees before you start turning the wheels. I have a feeling these gears cost a lot and should I rebuild the bottom while I'm at it? Well thanks!! RC
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|