Farmall & IHC Tractors Discussion Board |
Fixed 2 problems over the weekend on the M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon with an M on July 09, 2001 at 07:57:19 from (192.35.84.5):
Well I bit the bullet and dropped the belly pump on the 41'M. it was not as bad as I thought it would be. I dropped it out using a floor jack and 2 helpers to steady it. I had 2 problems. The first was while looking up under the inspection hole at the bottom of the flywheel housing I could see the clutch pilot bearing grease tube lying across the bottom of the housing. The only way i could get it out was to tie a wire to it through the hole, remove the belly pump and push the wire up around the side of the flywheel. This worked well, now I hope I can get it back where it belongs. The second problem was, after putting in 13 gallons of gear oil in the trans (I only got 3 out!) it was leaking out around the belly pump. come to find out it is the seal out of the tranny drive for the belly pump. All things concitered it was a good idea to drop the pump, the bad part was there was a rat nesting in there, now he is somewhere in the barn! I am enjoying tinkering on my M Jon M
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|