Farmall & IHC Tractors Discussion Board |
Thanks to all on Need a Fix for Weeping rearend
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on February 12, 2001 at 19:57:01 from (208.49.9.141):
While waiting for my welder friend to show, I started to change the front transmission seals on the countershaft and the upper tranny driveshaft. Got the nuts off of the driveshaft coupler but can't get the bolts out. Is this a "Must split tractor" scenario? IT Manual is worthless in this area. It appears that the bolts are pressed into the coupler halves. It also appears that the upper bearing will have to be replaced as there is a lot of play in the driveshaft of the tranny. By the way, the hole in the rearend housing is just a pin hole and not a crack. Don't think it will take much to seal it up. Rearend and tranny are drained, PTO is out and internals are wiped out clean. Thanks all.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|