This data has been gathered from old out-of-print material. While
we make every effort to be accurate, the information shown is to
be used for general reference only. It is always best to have
the original service or operator's manual for your tractor before
attempting any tuneup.
There is a legend at the bottom of the page describing some of the terms used here.
Spark Plug Gap
Timing Mark On
Int. Valve Clearance
Exh. Valve Clearance
Point gap for Magneto set to .015
Point gap set Splitdorf at .015, Fairbanks at .020
Today's Featured Article - Madison's County, Part 2 - by Anthony West. Following Phil’s little mishap at the week end, he had refrained from undertaking any of the restoration work on the Fordson County alone. Not that Phil is by any means faint hearted, it's just that the near miss had given him a different outlook when it came to working with heavy machines alone!! This had put the stoppers on the progress.
... [Read Article]
Looking for Case RO tractor restored or restorable
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.