Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Electrical problems!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 49 Cubber! on July 27, 2003 at 19:12:18 from (206.74.216.114):
In Reply to: Re: Re: Electrical problems! posted by Bob M on July 27, 2003 at 16:44:02:
Mistype on my part,was suppose to be 10 amps.But why do I get a discharge on low charge and why does the resistor get that hot?I havent changed anything on the switch section of the wiring,nor did I change where the wires were attached before I had problems.The only difference is the cutout is new.I really dont want to change to a regulator as like I said I have 3 on the shelf now that are "supposedly" good and make no doffernce in the way this system is now acting.It was like this for at least two yrs with no problems until it just quit charging.I had the old cutout on when i had it tested and the man who checked it at each shop confirmed it was the cutout.Lets say I give up and change to a regulator,what will I have to change in the wiring?Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|