I have a Tekonsha Prodigy in my F150 and it works fine. The '01 F150 was pre wired, I just got the proper pigtail and plugged it it. Took about 5 minutes to mount everything. When we got a new Suburban in '06, I specifically wanted the towing package - something I always get, and was assured by the dealer that the Prodigy would work. I got the proper pigtail for the Prodigy so I could swap it between vehicles. That's something I seldom do but wanted the capability. The pigtail would not plug into the slot under the dash. It was very close, but there was one extra little tab in the slot under the dash that prevented it from plugging in. After a lot of phone calls, found out that GM had changed things slightly and that the pigtails would not work on the new trucks. Further found out that the even if the pigtail would have plugged in, it wouldn't work because the wiring between the plug in and the rest of the system is not hooked up. All of the wiring was installed but purposely not hooked up due to "liability issues". Some of the wiring was laying under the carpeting, and the insulation had not been stripped off for installation. Dealer service department was completely unaware of this, I found out from internet searches and had to tell them, and they later confirmed that this was correct. The store where I got the supposedly correct pigtail was also unaware that the new GM's were different. Since I had specifically asked and had been assured that my brake controller would work with the new Suburban, the dealership ended up installing and hooking up everything for free. But it took several weeks to figure out what was going on. So don't assume that your truck is OK and the problem is with your controller.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.