Posted by fixerupper on January 10, 2008 at 08:42:32 from (216.51.182.132):
In Reply to: Trailer tie down-DOT? posted by Larry59 on January 09, 2008 at 19:01:39:
When we haul combines we ALWAYS use 70 chains,double wrapped on each end and double chained, one by each wheel.The long trailers we use flex and the combines are riding on big squishy tires, creating a situation where the chains will go slack and then snap tight again if the trucker lets the clutch out a little fast or the brakes are pumped a little quick. Many times we have stopped to check chains, only to find at least one snapped and dragging on the road. We could block them up,but that's just more stuff to keep track of, and securing the blocks so they don't move would take another half hour. These girls are loaded and unloaded all summer long.
Ratchet binders don't seem to hold up unless they're gigantic, so we use the kind of binders that have a loose handle after they snap over. It's kind of hard to explain but I'm sure a few of you have used them. They're expensive and hard to find,but they're just a little safer. The handles are double wired. We never use a pipe to pull them. Binder bars, or whatever the nickname is, are used always. You can control the twisting just a little bit better with them, and if the end of the handle hits something before the binder is snapped over, your buddy can stomp on the binder handle to complete the job.
There's a tramendous amount of energy stored up in those things, as you guys already know, and there's no completely safe way to use them. So far nobody's lost any teeth from a flying binder bar but one guy caught it in the head once. It made an awful sound but he just rubbed his head and kept on working.Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.