Posted by Skidhauler on January 10, 2008 at 05:20:38 from (75.104.160.38):
In Reply to: Trailer tie down-DOT? posted by Larry59 on January 09, 2008 at 19:01:39:
I haul tracked skid steers weighing 8000-10,000lbs at least weekly, daily in the summer. Others have helped you a lot--use nothing but the BEST chain as they have told you. Tie down all 4 corners and throw a chain over any attached imp as well.
As far as binders: The over-center binders you use a pipe on are not only dangerous, but a pain as well. You can get hurt, they are sometimes tough to get right--one link is too loose and the next link is WAY tight. In many instances,you need to wire the handle down. They sometime spin to where it is hard to get the pipe back on to loosen. If needed re-tightened,you then have to unwire the handle, get the pipe back out, re-wire the handle,etc. Plus there are cheap ones that will bend/spread apart at the hinge mechanism.
A good quality ratchet binder is safer and easier to use. Yes, they must be lubricated occasionally. The best thing about them is that when you check them after a few miles,all you have to do is ratchet the handle a little--no fumbling with wire, pipe, and no wild SNAP when taking them off.
Buy good quality chains and binders, and have brakes and lights on your trailer. Re-check the load after a few miles and bumps in the road.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.