Well i am one that has tons of USA made tools and don't care for junk , But i do have a harbor Freight angle headed die grinder that i use for gskt. removal with the scotch pads and i am well pleased with it as it has not gernaded in my hands YET i have one of them thar fine high dollar spray guns that i gave 11 bucks for and it has done the job for what it was bought for and it worked ok spraying the urethane finish on all the trim of this old house when we did the remodel i have four of there C clamps that i use for wood working and they are OK for that where your not applying lost of force just for glue up i bought one of there 1/2 impacts as i needed and impact now and leaving to go back hometo get my good one was not cost affective and it worded as well as my US made CP 745 , it heavier in weight and a little awkward but it got the job done . We needed a ten ton porto power to repair a round baler that got really messed up and my buddy bought one and it got the job done . Oh yea i have the 18 ga brad nailer and so far i have probably run five pac's of brads thru it from 1 inch up to 2 inch ones and it still works and again i don't have much in it and like the rest if it goes out to lunch then it will go into the trash as i got my less then 20 bucks out of it.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Cockshutt Tractor - by Danny Bowes (Dsl). The son of a very successful Toronto and Brantford, Ontario merchant, and himself quite an entreprenuer, James G. Cockshutt opened a business called the Brantford Plow Works in 1877. In 1882, the business was incorporated to become the Cockshutt Plow Company. Along with quality built equipment, expedious demand and expansion made Cockshutt Plow Works the leader in the tillage tools sector of the farm equipment industry by the 1920's.
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.