In my opinion, EVERY trailer should have its wiring ripped out completely any time something doesn't work right, or once a year, whichever is sooner.
I realize that some people buy quality trailers new from the factory, maintain them properly, and never take them off the pavement. They also either park them for the winter, or live where that isn't an issue.
However, I have never seen or worked on those trailers, all my experience has been with stuff that should be loaded up with scrap iron and left at the scrapyard after it goes across the scales. The owners don't want to hear about replacing anything, but will spend their life savings on Scotchlocks, electrical tape and other Band-Aids, also the labor to tinker on it and the defective equipment tickets.
Most of the problems I see are from poor grounds, poor grounds, and poor grounds. Then there is physical damage, corrosion, corrosion, and corrosion. After that comes did-it-myself, and in a hurry. And going back to cheap owners, whatever lights, wire, and connectors they could get at Walmart, or take off some other piece of junk they own.
I finished this and realized that it is more of a rant than any kind of useful advice for the original poster. It does sound as if there is still hidden damage from the original problem, and a complete replacement of the wiring may be a real short cut in terms of labor and frustration.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.