I have a bubble balancer I bought on ebay for $12. I use it all the time.
A few years ago, there was a Nebraska Tire store come into town. They're a small chain of 6 or 8 stores. They had good deals on tires, but I was never impressed with their balancing, even though they had a fancy computerized balancer. After I got this bubble balancer, I took a couple of wheels with tires mounted to them and had them balance them. When I got back to my shop, I put them on my bubble balancer without ever mounting them on whatever vehicle they went on and they both tilted to one side on the bubble balancer.
I don't know if it was their machine or the operator, but the store only lasted a couple of years and I always wondered if too many other people had problems with their balancing.
Actually, I think tires nowadays are better made and don't require the balancing they used to, maybe just 20 years ago. Of the last set of tires I put on my wife's Chrysler minivan, two of the four "pinwheeled" the bubble on the balancer without any weights, and the other two were inside the ring but took only a half ounce or so to center it exactly.
There are a few tricks to a bubble balancer, though. If you need one ounce of weight, instead of one one ounce weight, you might want to use two half ounce weights a few inches apart, etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.