Farmall & IHC Tractors Discussion Board |
Re: Farmall hydraulic troubles.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on December 27, 2006 at 21:50:54 from (24.223.138.48):
In Reply to: Farmall hydraulic troubles. posted by Berry450d on December 27, 2006 at 19:48:24:
Hopefully u added the hydraulic fluid before u ran it. running the system dry is murder on the pumps. I doubt the pumps need primed, as the pump is below the resevoirs and any air would be quickly replaced with fluid. Maybe try to loosen the output of the pump and see if oil comes out. If it doesnt, maybe the pump gear is stripped or the fluid filter is clogged something bad. I'm not sure on the specifics of the 2 tractors you have, but these ideas should give you a starting point. Any things you have tried would be helpful.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|