Farmall & IHC Tractors Discussion Board |
Hydrolic Plumbing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on October 31, 2006 at 16:37:23 from (64.12.116.65):
As I have mentioned in earlier post, I have acquired a 3 point hitch for the H. The hydrolic lines did not come with it. It has two cylidners that will have to be hooked up to the hydrolic system. So, somehow, I must have a line fabricated to go from the fitting on the pump housing, back across the deck under the seat and split with a "T" of some kind to supply eacy cylinder. I don't have any experience with fabricating hydrolic lines. The fitting in the elbow off the pump seems to have a regular pipe threat in it. So, I will look around and hunt an end fitting to be put on the supply line that fits that elbow and then run it to a manifold of some nature in the rear. It seems to me, that the maniforld in the rear should have 2 quick disconnect fittings for the supply lines to the Cylinders. What I am doing here is asking for specific recommendtions regarding the selection of the fittings and the fabrication of the lines. Can anyone help? (I can get the local NAPA store to install the fittings on the lines)
Replies:
Home
| Forums
Today's Featured Article -
History of the Cockshutt Tractor - by Danny Bowes (Dsl). The son of a very successful Toronto and Brantford, Ontario merchant, and himself quite an entreprenuer, James G. Cockshutt opened a business called the Brantford Plow Works in 1877. In 1882, the business was incorporated to become the Cockshutt Plow Company. Along with quality built equipment, expedious demand and expansion made Cockshutt Plow Works the leader in the tillage tools sector of the farm equipment industry by the 1920's.
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|