Farmall & IHC Tractors Discussion Board |
Crank M for Murder...
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by A. Bohemian on May 03, 2007 at 07:16:27 from (207.170.88.43):
In Reply to: Re: magneto for farmall m ? posted by Andy Motteberg on May 02, 2007 at 16:38:29:
Hitchcock got it wrong. In addition to being dangerous, cranking a large engine such as that on an M is very strenuous exercise. In fact, if you watch a lot of film comedies from the 'twenties and 'thirties, you can identify a rather common comic type: the big, powerful liveried chauffeuer who is just about to pound the daylights out of W. C. Fields, Laurel and/or Hardy, Buster Keaton, Harold Lloyd, Harry Langdon ("Harry Langdon?"), etc., when he is at the last moment restrained by the mild-mannered little old lady who employs him. The reason this joke was played so often is that chauffeurs had to be BIG to crank that Locomobile, Peerless, Packard, Biddle, Rolls Royce, Pierce Arrow, etc., etc., in the event the battery ran down. Now, the engine in an M is nowhere near as big as the one in an Hispano-Suiza; but it is big enough to be VERY difficult to turn over, especially if the compression is good.
Replies:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|