Ultradog MN
Well-known Member
- Location
- Twin Cities
I'm welding some new tie rod ends on my Ford. I could have bought new or aftermarket ends but these were about 1/8 of the cost so worth a little welding/grinding.
But this one didn't have a grease zerk in it. So I'm going to add one.
My question is: how would you go about doing that?
I know, I know. Drill and tap.
But how would you go about it?
I have a plan.
Just wondering how many others here would have the same plan.
But this one didn't have a grease zerk in it. So I'm going to add one.
My question is: how would you go about doing that?
I know, I know. Drill and tap.
But how would you go about it?
I have a plan.
Just wondering how many others here would have the same plan.