Willow Lane
Member
- Location
- Central Maine
I tried to replace a yoke on a PTO shaft yesterday and run into a new to me problem. I removed the locking clips and pressed the cross sideways to remove the first cup, which typically pushes the cup out of the yoke, but the cross bottomed out on the yoke before the cup was out of the yoke. I clamped the cup in a vise and tried driving the yoke off, but no matter how tight I had the vice, all I did was drive the whole assembly out of the vise. Any suggestions on how to get the cups out without destroying either the yoke or the cross?
Thanks
Thanks