Geo-TH,In
Well-known Member
I fixed the front end on terramite.
Used 4 washers to lower new part of the spindle 3/4 of an inch so I can use part of the spindle that was not used.
I reamered where the tie rod ends go in in spindle, then made a shim. Tie rods are not moving like before.
My work comes with a lifetime warranty.
As long as I alive I'll fix it for free.
This is better than when I bought it 10 years ago.
No JB weld was used ever.
Should good up to 5 mph. That's as fast as it goes.
Used 4 washers to lower new part of the spindle 3/4 of an inch so I can use part of the spindle that was not used.
I reamered where the tie rod ends go in in spindle, then made a shim. Tie rods are not moving like before.
My work comes with a lifetime warranty.
As long as I alive I'll fix it for free.
This is better than when I bought it 10 years ago.
No JB weld was used ever.
Should good up to 5 mph. That's as fast as it goes.