Hi All,
As mentioned previously I am working on a Ford 9N project with the mechanics class I am teaching.
We have reached the point at which we are ready to begin to install the sleeves and reassemble the motor. This tractor takes .040 thin wall sleeves and we are trying to avoid breaking them. We currently have them in the freezer to shrink them as well as the block in a classroom which is about 70 degrees, but we are not sure that this will be enough. We also do not have any sort of tool to use to install the sleeves, and do not have the ability to make the tool or have the tool made.
Any suggestions or advice for the installation of these type of sleeves?
Thanks in advance,
~FarmallCT
As mentioned previously I am working on a Ford 9N project with the mechanics class I am teaching.
We have reached the point at which we are ready to begin to install the sleeves and reassemble the motor. This tractor takes .040 thin wall sleeves and we are trying to avoid breaking them. We currently have them in the freezer to shrink them as well as the block in a classroom which is about 70 degrees, but we are not sure that this will be enough. We also do not have any sort of tool to use to install the sleeves, and do not have the ability to make the tool or have the tool made.
Any suggestions or advice for the installation of these type of sleeves?
Thanks in advance,
~FarmallCT