(800) 853-2651
SHOP NOW

Hydro 186

A

Allan in NE

Well-known Member
Engine bearings from the ground up. I do not recommend.
a259848.jpg
 
Mud my first thoughts is that the guitar man back... Allan good to see you post. Hope you have been doing fine. I have done a few ih 466 in td 15 dozers from the bottom, not easy and makes for some tired shoulders and neck.
 
Need a creeper with adjustable height . I used to put blocks under the creeper but of course that makes it pretty immobile. After I retired I made an extended height creeper. Too little too late.
 
I don't envy your position :-( If you put a pallet down with some plywood on it then the cardboard you don't have to work at the end of your reach, might help the shoulders. Good Luck with it!
 
Groundup bearings, Nasty. What caused it. Just kidding. How is the Massy. We missed you a bunch (it has been commented on) Jim
 

I was surprised that I was still getting oil in my face after two weeks. I laid on my creeper so that I didn't have to reach so far.
 
I never responded but i always enjoyed reading about Allen in Neb. Especially about his transmission work. None better in my opinion. I recognize talent when i see it.
 
You must log in or register to reply here.

Similar threads

O
Information wanted on International 186 Planter
Replies
5
Views
358
Oliver770WY
O
tomstractorsandtoys
Big shop project
Replies
3
Views
1K
J.Wondergem
J.Wondergem
M
Tractor HP recommendations…
Replies
15
Views
1K
jwal10
J
N
1952/8N side distro-Trans Oil question
Replies
9
Views
337
Tim PloughNman Daley RIP
T
tomstractorsandtoys
John Deere 95 combine
Replies
8
Views
2K
GermantownGreen
G
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top