A/C Model 210 Disc parts

Mo in NE tex · May 10, 2017

I've been trying to find parts for my A/C Model 210 disc harrow and not having any luck. It is a 10' hydraulic lift pull type disc and I'm in need of a new axle and four 7 1/4" spacers. The axle is 1" round and s/b about 58" long. Any idea of where to look. I have tried Agri Sup but 48" is longest they show. The spacers are two piece, but a one piece should work. This has been a good disc and does an excellent job until I loaned it out and he let the disc's get loose on the one front gang and wore the spacers and broke the axle when trying to turn with disc still down. Lesson learned, don't loan equipment out.

rustyfarmall · May 10, 2017

I was given a similar A/C disc a few years ago because it needed new bearings all the way around and none were available anywhere at any cost. I parted it out. Made use of a few of the blades and some of the iron from the frame. There is very little of it left. Previous owner replaced that disc with a John Deere. He can still get parts for that one.

Mo in NE tex · May 10, 2017

After breaking it all down and putting my brother on the smart end of the tape measure, it disc will cut 9 ft at the back and 8 ft at the front. Each axle shaft is 48 inches. I replaced bearing some time ago and they are still good and tight. If all else fails, weld the axle back together and do the same with the spacers to make them the correct width. Old welder friend welds more cast iron than all of these young fellows put together around here. But was wanting to keep it going for the rest of my time.

Butch(OH) · May 10, 2017

AC made a ton of those disks and there is more than a few around being parted out. If you go to the all allis chalmers site and ask you will surely find the parts you need. Sorry but cant post a link to it here.

2underage · May 10, 2017

Google "shoup parts". They have a lot of disk parts.

Eldon (WA) · May 10, 2017

(quoted from post at 10:45:47 05/10/17)
I was given a similar A/C disc a few years ago because it needed new bearings all the way around and none were available anywhere at any cost. I parted it out. Made use of a few of the blades and some of the iron from the frame. There is very little of it left. Previous owner replaced that disc with a John Deere. He can still get parts for that one.

There are a number of bearing concoctions that people have developed lately that will replace those ballpac bearing. You just have to go to an AC forum and ask.

donjr · May 10, 2017

Call Ag Supply Co. They have always had the parts I have needed, and they have been here in a couple of days, UPS, and at a reasonable price....

A/C Model 210 Disc parts

Mo in NE tex

Member

rustyfarmall

Well-known Member

Mo in NE tex

Member

Butch(OH)

Well-known Member

2underage

Well-known Member

Eldon (WA)

Well-known Member

donjr

Well-known Member

Similar threads