tim ferris
New User
looking for creeper gear for my farmall super c tractor.
- Thread starter tim ferris
- Start date
Janicholson
Well-known Member
You can make one using a 5 HP Hydraulic motor. Use the belt pulley for trans input Run a 14 inch sprocket on it and a 2 inch sprocket on the hydraulic motor (you figure out the appropriate ratios, these are guesses) The trans is placed in neutral, and the hydraulic motor operated from the Live Hydro, or a belt driven hydro pump to make it go. It does prevent the use of the PTO. and it is for planting. or other slow work not draft loads. Jim
Similar threads
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy