Have a MF35, 6 Speed, dual clutch, non-multipowered tractor looking to replace the input shaft seals. Can this be done without access to the gearbox? I am planning to split the tractor for some clutch work and wanted to replace them while I was in there. Seen Bundy's video's and read some other comments and I am not clear if this can be done as the gearboxes were already dismantled for other work/restoration. My manual briefly goes over this but does not mention it either way.
I don't want to lose access to anything that may slip or fall behind the bell housing.
I don't want to lose access to anything that may slip or fall behind the bell housing.