|
Phil (VA)
01-27-2003 06:56:11
|
|
Re: bucket loader for TO-30 in reply to Mike, 01-27-2003 04:09:35
|
|
| |
The loaders that fit the 9N, 2N, or 8N Fords will fit the TO-30. The loader front pump can be driven off the front pulley on the tractor, same as on the Fords. I have a Wagner WM3 on a TO-30 that came off an 8N. It bolted right up, using the same bracket for the front axle that was used on the Ford. The stinger for the pump and pulley was close to the correct length and with a few washers to shim it works fine. You may need an adaptor for the pulley, available from dealers. This style loader bolts to the rear axle using the fender bolts, so it must be the exact length, unless you plan to fabricate brackets, etc. Consequently, loaders of this style that fit the NAA or TO-35 (longer tractors) will not easily fit the TO-30, but the loaders that fit the 8N, etc., fit very well as they apparently are the same length axle to axle as the TO-30. Having said all that, with this style loader, the TO-30 has the problem of not being able to raise the hood once the loader is installed. You will need cutouts for the fuel and radiator, etc., or else cut the hood and install clamps. The latter is especially needed for battery maintenance. Hope that helps.
|
|
|
