Posted by Dave from MN on May 04, 2011 at 17:08:45 from (75.94.148.103):
related to the MCV, the plug that holds in the pressure regulator valve and spring into the MCV. One thing I did notice is that the 1206, and this nightmare06, have 2 different plugs. The one on the 1206 is a flush flat plug, while the one in the nightmare had about an 1/8" protrusion or extention in it. Could this possibly be causing the pressure regulator valve to not operate properly? I know I can hold the pressure back on the bleed screw, but before I swap just for s's and g's, I thought I would ask. I am also going to reasemble the brakes, which will have new springs, new pads, in spec plates, adjuster plate is about .400" thick, intermediate plate is .645" thick, and I beleive pads are .440" thick. The adjuster springs seem to be good. It seems like if there was no "insulator" on the piston, things would measure out alot more even. Guessing NOT having that bonded insulator is a bad idea huh?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.