Some flow from the brake valve in the off position should be OK as long as it does not build pressure. I think you will find that your problem is in the return springs. They almost always need to be replaced when the linings are replaced. Your old ones may feel OK but if you match them up with new ones you will find that they are now too short.
As the brakes are applied the piston pushes against the adjuster plate which pushes in on the springs. The more the linings wear the more the springs are collapsed. When the brakes get hot the springs will lose some of their temper and no longer apply the same pressure to retract the piston allowing the brakes to drag causing the brakes to get even hotter.
The brake adjusters work to limit how far the piston is pushed back into it's bore. If there is a problem with the adjusters it is usually either that the brakes are slow to apply because the piston has retracted too far and takes too much oil before applying the brakes or poor braking because the adjuster screws are seized they are keeping the full pressure of the piston being applied to the linings.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.