Posted by Brad Gyde on March 10, 2011 at 06:07:07 from (184.216.191.17):
Hey guys,
I asked this question in Farmall board, and I'm not really getting the answer I am looking for.. so I'm gonna ask here.
I'm converting my Farmall cub over to 12V. It will still be generator, NOT an alternator. I'm not sure if it had a cut-out on it before or not, I believe it should have been a voltage regulator.. All i can do is ask the rebuilder when I pick it up if it was a cut-out or a V-reg.
The way it was wired when I pulled it seems to be the 2 posts of the generator were connected to the V.reg/cutout and the 3rd wire appears to run back to the "switch box"
Will I have to do any wiring change? If I do, can someone help tell me what I'd have to do?
I already understand I have to change the regulator (which will be done by the rebuilder) and that swapping to negative ground would be better, and that I have to change light bulbs. Mag ignition, so no change of polarity on the coil, will have to change polarity on ammeter though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.