Posted by Inno on August 16, 2010 at 06:19:26 from (70.54.184.7):
After careful research and consideration I have decided to abandon the factory power assist steering on my 202 Massey Ferguson industrial. The cylinders and hoses had been stripped off it years before I owned it and with the front end loader I have been struggling to steer it and destroying the ball screw on the steering shaft. The ports on the control valve were left open so water got in and pitted all the mating surfaces very badly. So essentially every thing would have needed replacement, BIG $$$ and I'd still have an old steering system. Being as how there is no kit for my machine (probably because it had power steering from the factory) I have done a lot of research and found all the parts I need from various places. There will be no physical geared connection between steering wheel and front axle but I have left the sector gears in place to keep the front wheels doing the same thing at the same time. E-Bay saved me probably $500-600 so far. It is based on a Char Lynn rotary steering valve getting power from the FEL hydraulics through a priority flow dividing valve. So if all my calculations are correct I should have full blown hydrostatic power steering within a week or two.
If anyone is interested I will take lots of pictures and document my work here. Then once I'm done (and if it all works as I hope it will) I will be able to answer questions for people who want to do it themselves.
This post was edited by Inno at 06:21:12 08/16/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.