Posted by kyle.fenstermaker on July 27, 2010 at 13:22:23 from (143.79.13.6):
I bought a short block from Country Sales and Service out of Orville Ohio. The motor lasted less than 30 hrs and spun the center bearing on the counter balance shaft. I tore the engine down to the point of removing the defective shaft and had a local John Deere service department verify the shaft. They had checked the shaft and stated it was bent beyond their tolerance for re-use. The service technician even came to the house to look at the engine a little closer and said the bearings showed all the signs of a bent counter balance shaft which it what caused the center bearing to spin out of the block. Anyone who has ever dealt with building engines know that when a bearing spins it will create debris in the oil. With this being said, Country Sales and Service Rep wanted me to send them the defective parts so they could send them to there warranty company Maxiforce out of Miami Fla. In Maxiforces review and statement concerning the defective parts, Maxiforce even stated the shaft was bent, but it would be up to them and Country Sales and Service for the replacment of the parts. Well guess what, they have said they won't cover any of the damage because there was debris in the oil. (Well no kidding)Spun Bearing guys!! The main bearings and rod bearings are inpregenated with debris, but was caught soon enough not to cause damage to the crank. Country Sales said they no longer put re-conditioned shafts in there engines because of situations like this. They supposedly stand behind their Quality Work and Parts ~Bull~~~T! If any one else is looking to purchase anything from these Jokers ~ You may want to think again. I could go on the tell more crap they did from the beginning but I think I got the message across. Sorry to everyone, just had to vent!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.