Tractor Talk Discussion Board |
Correct dyno operation
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JS on June 30, 2001 at 20:16:07 from (152.163.197.53):
I have been fortunate enough to have access to a dyno to check my tractors. Directions I were given: 1. Set factory RPM on tractor. 2. Hook up dyno (warm oil to operating temp. 3. Engage pto and apply drag until pto rpm to 540. 4. Read gauge for HP. I followed these directions on an Allis wd45 diesel, turned 52.5 hp @ 540 pto rpm and immediately dropped when appyling more drag. I then put an Oliver 88 diesel on it, turned 35 hp @ 540 pto rpm and climbed to 57 when I applied more drag. Is this correct operation, and on the oliver how many hp does it have, 35 @ 540 or 57 when drag aggressively applied? My goal is to become a little more competitive at the pulls. Thanks for any input on this subject.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|