Posted by JD Seller on May 31, 2010 at 18:14:58 from (208.126.196.117):
In Reply to: 98 Jeep Laredo posted by J Heitkemper on May 31, 2010 at 17:33:16:
1) Remove the rear u-joint. 2) Then remove the yoke retaining nut. You will need a good impact wrench. You might even need to heat the nut to get it off. Some of them use lock tight from the factory. 3) Remove the yoke off of the input shaft. Don't push it back in to the case it has bearings and spacers on it. 4) Take a small pry bar and remove the old seal. 5) Clean the seal bore out with some brake/parts cleaner. 6) Find a socket that is the slightly smaller than the OD of your new seal. You will be able to use this as a seal driver. Apply a small amount of silicon on the OD of the new seal. I just put a little on my finger and wipe the out side of the seal. Drive the new seal into the rear end housing. 7) Reinstall the yoke and then tighten the retaining nut. You should really use a torque on that nut. (I don't know the the torque need for this application) 8) Reinstall the rear u-joint and check the gear oil level in the rear end. You should be ready to go.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.