SJ said: (quoted from post at 06:12:31 03/08/10) Congrats Dave,I dont know how you do it,but man I envy you.When we got into horses 7-8 years ago I had planned on breeding and the whole nine yards.Built a barn,fenced in pastures.But with my job,trick work,lots of hours,one hour commute each way and the cost I just cant do it.Do you have an outside fulltime job?
Lookin forward to the pics.
Stan
We just kinda fell into it....We both grew up with horses. FF and we got together, bought an old farm with a few stalls. Got a horse (gelding) and decided he was lonely. I wanted a quarter horse and wife bought me a mare for my bday. 2 or 3 years later we had her bred and again the following 2 years, got a stallion because we were were tired of driving and paying for service. Imported 4 mares from the States over the last 4 years and I get to shovel a lot of sh!t. We both work full time. I think we wouldn't be able to do it in the States and be comfortable. Here, everything we need as far as feed is within a mile. There is a market for good horses and a butcher for not so good ones. So far they pay for themselves and give us room to play a little.
Only pic I have at the moment is on the website below (have to copy/paste). He's the lower one (black). Soon as the other pics get downloaded and sorted, I'll post some.
The rest of our horses and some past babies are scattered around the site if you feel like clicking around.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.