Posted by ben brown on October 19, 2009 at 04:45:00 from (72.173.160.58):
In Reply to: Fuel in the engine oil posted by Don McCullough on October 18, 2009 at 15:22:37:
no i dont have a 5020, but i do repair a lot farm equipment,, that type pump was use on a whole lot of different tractors so have replaced a lot thoes seals. i remove injuction lines from pump and injuctors any other line going to pump. it not nessary but a good idea if its firts time to put engine in time remove the little side plate, and line up pump timming marks. the drive shaft with seals well stay with pump. replace the seals two unbrella style seals.one faces towars front one towars back of tractor,, the first one in is a littel trickie to get it to slide into pump once you get it worked in slide the pump back anf forth making sure that seal is not folded back or it well leak the o-ring is on end of pump.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.