Tractor Talk Discussion Board |
Save that tractor tire with the cut sidewall (tip)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The poor farmer on December 09, 2000 at 18:46:56 from (205.188.197.177):
Have you got a rear tractor tire with a cut in the sidewall that a boot won't fix? If you do, make a metal boot and keep on driving.Metal boot: Cut a piece of soft aluminum sheet about four inches wide and long enough to cover the cut area.Cut a piece of tire sidewall the same size. Drill 1/4 to 5/16 holes in both pieces(drill them together so the holes will line up). Use one as a pattern, and drill the four holes around the cut area from the outside. Obtain four smooth headed carriage bolts that fit your boot and bolt the aluminum part on the inside of the tire and the rubber part on the outside. Use a mallet or round tool to make the alum. sheet conform to the shape of the tire. make sure the round head of the bolts are on the inside of the tire and there are no burs on the bolts or alum. sheet.Brad the nuts on the outside of the tire and go. DO NOT run with low pressure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|