Posted by Derrick Gross on June 21, 2009 at 20:14:37 from (205.149.144.70):
Help..........I have a problem with my truck.
It's a 1996 GMC Seirra 2500.
It was in the shop about 1200 miles ago for some repairs, most of which were unrelated to the current problem; brakes, ball joints, ect. It also got a tune-up, some fouled plugs were replaced, and the oil was changed; which may be related to the current problem.
Yesterday, on the way to town, I noticed a clicking sound. On the way home it went away and everything seemed fine. No idiot lights, no abnormal gauge readings, no more noises.
Today, on a trip to my in-laws, the noise started up again. As the trip went on I noticed the oil pressure gauge bouncing up and down. By the time I got home it was dropping to zero but not staying there. The truck sat for awhile. When I started it again; that's right, I started it again without checking the oil....you can guess where this is going......the gauge read 0 for several seconds then popped back up to normal.
If the pressure gauge was up (40 or so) little or noise could be heard. The farther down the guage went the louder/more intense the noise gets.
At that point I finally decided it wise to check the oil so I pulled the dipstick............ NOTHING!
Okay, I know it was stupid to ignore the noise in the first place and I should have checked it out yesterday; but I didn't............
There are no obvious leaks. The valve coverers are clean, no oil drips underneath, or other obvious signs of oil loss. Of course I'm obviously not an expert. The one thing I did find is moisture inside the tail pipe. I rubbed my finger in there and.........black!
Is this a head gasket? If not what? Could this be connected to the work done on the truck last week? Any other thoughts, ideas, advice, suggestions or comments: other than I should not have driven it after hearing the noise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.