Tractor Talk Discussion Board |
Movement in water pump pulley - any suggestions ??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on June 26, 2000 at 08:47:20 from (198.161.119.4):
I've got a Massey 101jr with a 4 cylinder Continentaly flathead engine. The water pump pulley is mounted on the pump shaft using a half-moon key and is held on with a nut and a lock washer. Even when it is tightened up, there is side-to-side play (wobble) between the pulley and the shaft. I suspect one (or both) are worn somewhat). I have used some shim stock to take up some of the slack but I can't seem to get enough in that solves the problem because getting the pulley on becomes impossible. The amount of play is not great, but it's still there. I have considered drilling and tapping out the pulley and putting in maybe a 3/8" set screw to firm things up. Do you think this might do the trick? Any other ideas that might help out? THANKS !
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|