Posted by Clefus on February 23, 2009 at 18:41:21 from (75.117.130.251):
In Reply to: OT Sharpening a knife posted by F150Mustang on February 23, 2009 at 14:37:28:
I skin a lot of critters in the fall and got tired of wasting time sharpening...
I have ended up using a Dunn system..mounts on a bench grinder ..one wheel has grit to put the inital edge..other wheel uses buffing compound to put the finish on....I have a cheap bench grinder Ive comitted to this...saves taking wheels on/off...
Note: make sure you lay knife on wheel properly...I had to put a note on my grinder so in case someone uses it they know it turns backwards....I mistakenly shot a knife across the garage due to forgetting about the rotation.. :shock: I have the grinder flipped so that the switch is facing away....this allows me to lay the knife on top of the wheel to better see the edge forming...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.