Posted by Roy in georgia on July 09, 2008 at 16:26:19 from (98.17.177.239):
In Reply to: O.T. F350 Clutch woes posted by Kevin (FL) on July 08, 2008 at 20:53:57:
that trans is heavy as others have said but the shifter comes out easily I think 6 torx bits at the top I remove the transfer case from the trans before trying to pull the trans. when dealing with a 4x4 it just makes it easier to handle and gives you more room to wiggle the trans out and in and the transfer case is easily removed (win win) the rear of the engine will be fine as long as you have the trans jack under the trans the weight of the trans will pull it down when the cross member is removed and I don't like that but the engine alone should be fine.that truck should have the upgraded flywheel (one piece) if not that may be your problem the 2 piece flywheels make noise like metal but the clutch spits the springs out too then the clutch won't disengage (in most cases)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.