Melting around the battery terminal is a dead giveaway for a poor connection. If the cables themselves are hot, they're way too small. Being positive or negative ground has nothing to do with it, but being 6 volt does. Warm engines are tighter than cold ones and typically harder to turn over if the battery is marginal or the cables are too small.
6 volt starters draw twice the current than equivalent size 12 volt starters do, plus a lot of automotive type cables are designed for small car engines which use relatively small starters & don't draw a lot of current.
6 volt starter cables should be at least 1/0 or 2/0 wire size. What you typically find at the corner auto parts store is #4, which is three or four sizes too small for a 6 volt system.
Any place that deals with heavy equipment or over the road trucks can make you cables. Just give them the length and the size of the lug(s) on the end. NAPA can order them, but they're expensive. I've also made my own using welding cable and crimp/solder terminals.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.