Basically, when you're sawing, you never let that chain get any duller than when you know it's dull already. By not allowing it to get any duller, you eliminate the chances of rounding the crest of each cutting edge (the flat dog where the cutting edge is found). By sharpening when saw performance shows signs of faltering, you'll save time by making two or three swipes with the file per edge compared to 6 or 7 per edge when you've rounded over the whole edge.
As mentioned, you'll never see a good logger using one of those sharpener contraptions. It is not hard to do, just be patient, and go with the angle of that edge (provided that you did NOT let it go too far). Make sure you use the right file for your chain - stihl has a guide specifically for this
There is such a thing as having a chain too sharp. I know everytime i get that chain too sharp, the saw won't pull it through the wood.
If you're making 1/4-3/8 inch chips, you're making double time. If you're only putting out salt and pepper, you got to get that chain sharpened fast.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.