Posted by rustyj on December 30, 2007 at 08:43:26 from (96.236.149.16):
In Reply to: ground for a trailer posted by johndeereman on December 27, 2007 at 16:47:26:
I towed a travel trailer around for a bunch of years, and here's the way i handled the trailer ground problem: I fastened one end of a wire to the frame of the trailer, with a loop end, and a bolt and nut and lock washer! On the other end of that wire, i installed a double wire connector, like used on autos and trucks, to connect wires together. Matters not wether it has the prong sticking out. The other piece of wire, i fastened to the truck frame the same way. On the other end was the corresponding connector. The wires were fastened down with metal clips, but you can use plastic wire ties now. (Didn't have them back then!) When you hook up to the trailer, just plug the extra wires together, and you will have a good trailer ground, and your electric brakes will work. A bit of axle grease where the wire is bolted to each area, will tend to stop any rust from forming. The travel trailer came with a wiring schematic that showed the way to connect the wiring to the tow vehicle, including the break-away switch, which was required on the larger trailers. That switch applied the brakes if the trailer became disconnected from the tow vehicle. It is State law in Pa.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.