Tractor Talk Discussion Board |
Bearing to shaft oil clearance
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by dr.sportster on January 20, 2005 at 13:15:46 from (209.247.222.82):
Several days ago a guy said here that he had replaced motor bearings with new standard size bearings.Needless to say he reassembled to find the same loud knock.I beleive this is why;Recommended clearance-.0015"-normal oil pressure.double claerance.003"-provides five times normal oil supply Double again to .006" clearance provides 25 times normal oil supply.As excessivly large clearances are approached the danger of oil starvation is introduced.This is a result of the bearings nearest the pump receiving ALL the oil supply and the furthest not getting enough.I didnt want to tell him he just wasted a set of standard bearings.Reference: ENGINE POWER BOOK
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|