Tractor Talk Discussion Board |
Re: Cub Cadet 682 Hydro
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on May 19, 2004 at 08:23:45 from (66.163.134.177):
In Reply to: Cub Cadet 682 Hydro posted by Dave on May 18, 2004 at 16:17:44:
Before condemning the clutch, be sure the connections are clean on the circuit breaker, and possibly change the breaker. I agree with the others, it most likely is the clutch, but circuit breaker problems will cause the same symptoms, and a breaker is a heck of a lot cheaper than a clutch. If you do have to replace the clutch, the movement backwards of the clutch plate, away from the driving plate, causes it to contact the BRAKE plate. There is an ajustment where you draw the brake plate bolts down evenly untill there is a specified clearance, in thousandths, between the plates, which you measure by inserting a feeler gauge through slots in the clutch. Be sure to get the correct spec, and the exact procedure, 'cause if this is not set up right, it's near instant death to the new clutch.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|