Tractor Talk Discussion Board |
Re: coil replacing a magnito
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wh on August 10, 2003 at 06:36:48 from (208.61.210.66):
In Reply to: coil replacing a magnito posted by Dave on August 09, 2003 at 19:24:41:
take the top off your mag coil. cut the wire going from your coil to the condenser. cut it "clean" and cover it if possible. put he top back on the mag. mount a coil anywhere it is handy. i made a small bracket and put it between the oil filter and mag. run your wire from the switch to the coil an dfrom coil to the terminal on the outside of your mag. you will need to either buy a coil with internal resister or put one between your switch and coil to get the current back to 6v. have a setup like this that was done about 30 years ago and still works liek a top. wade
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|