Tractor Talk Discussion Board |
WD-45 3pt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by randall r baldauf on May 06, 2003 at 05:17:38 from (209.206.209.65):
I got on this page back in the fall and asked for ideas on how to build (NOT BUY) a 3pt conversion for a WD-45. Dennis Springer was good enough to send me some photos on his conversion for a D-17, and was working on one for a WD-45. I e-mailed him with my question but the mail was returned. Any way I got the lower end built and mounted but had questions on the mount for the top link. I took a 1/2" ubolt around the shaft for the lift arms and put it through a piece of 1/2" plate and was going to weld two ears to that for the top link but I don't like the way it rotates as you put the lift arms up and down. Anyone have any experence with mounting the top link? Does it matter if it rotates? Thanks in advance. Randy
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|