Posted by super99 on June 05, 2022 at 17:52:38 from (184.20.235.0):
I'm having issues with my gooseneck tractor hauler lights. All lights work except left turn and left brake lights. I have power to the plug in and power to the junction box on the trailer, it seems to me the problem is in the wire going from the junction box to the tail lights. All of the wiring is inside conduit so it's almost impossible to see where/if there is a bad place in the wire. The crazy part is that the first time I pulled it out of the shed, I had no brakes and no left turn signal or left brake lights. I unplugged it and when I had time to work on it a few days later, now I have brakes but no left turn or brake lights. I checked at the back of the trailer and have power for the running lights but not for turn or brake lights. I installed a new taillight but that didn't help, I didn't think it would, but had to be sure. How can I check the wire from the junction box to the back of the trailer? Or should I just run a new wire for brake lights?? Did I mention that I hate working on lights?? I have a small multi tester, could I add enough wire to run from junction box to the back of the trailer to test continuity of the brake light wire, the trailer is 27'+ a 5' beaver tail, so close to 35' of wire to check the continuity with my little tester. Thanks, Chris
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.