Posted by andy r on March 27, 2022 at 20:10:16 from (208.126.193.44):
Most of the John Deere maximerge planting units I have worked on have the roll pin holding the gauge wheel bearing in the gauge wheel arm. I have converted two planters over to the bolt on gauge wheel. Started work on another John Deere planter with the bearing that has a groove in the shaft that a set screw set in and holds the bearing in the gauge wheel arm. I have not worked on the set screw type before. What I noticed immediately is that all of the short little stubs that stick out of the bearing wobble in the gauge wheel arm. They are loose. I never had that with the original roll pin type. Is the gauge wheel arm or the shaft on the bearing worn out or is that the way they are? The actual bearings seem good yet - the problem just lies in where the bearing attaches to the arm. I don't know if sleeve locker would help take up the slack? Hate to replace them as the other end that attaches to the planting unit is the updated quick adjust style. Appreciate any advice.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.